ACDelco Enhanced Flooded Battery (EFB)

Today, vehicles demand more of batteries than just starting power. Over the last 20 years the requirement on a vehicle’s electrical system has increased dramatically. Many vehicles now have Stop/Start technology and dozens of power hungry on-board electrical modules that require an advanced vehicle charging system and more importantly a battery capable of handling this increased load when the vehicle’s engine is not running. In addition, they must also deliver the necessary starting capacity to start the vehicle in a fraction of a second when the brake is released or the accelerator depressed

Longer lifespan compared to conventional battery

Designed for vehicles with “Start-Stop” systems

EFB (Enhanced Flooded Battery) technology provides consistent high performance for vehicles with customized accessories

Clean production – consumes less than 20% energy and emits 20% less greenhouse gases, closed-loop recycling circuit with ecosteps® program – conserving resources and protecting the environment

Full Frame Grid technology for high power output during start-up and reliable performance

ACDelco Battery Charger help avoid overcharge by reducing the charge rate as the battery nears full charge. Follow instructions provided with the charger

Determine the charging time that will be required. Check the built-in indicator and charge the battery for at least the number of hours shown in the charging table (located in “Charging Instructions” section). If the green ball is not visible in the indicator after charging, tap lightly on top to dislodge trapped air bubbles that might keep the green ball from floating into view. For the most accurate results allow the battery to rest for 12 hours then measure battery voltage, 12.8 volts is fully charged.

NOTE: A more definite charging time can be set if an accurate voltmeter is available for reading open circuit voltage.

DO NOT leave a battery connected to a battery charger after the battery is fully charged. Inspect battery every 2 hours when charging.

Keep battery in a cool place when storing for long periods (make sure battery is fully charged – a discharged battery’s electrolyte can freeze).

Keep battery terminals clean and free of corrosion. To remove corrosion from terminals, use a terminal brush.

For maximum battery life where electrical requirements are high, separate starting and running batteries are recommended.

BACKED, TESTED AND PROVEN

All Products >